3 ms·
> A shorter distance that is closer to the combustion chamber increases the compression ratio because there is less space for the fuel/air mixture. When the sys
by pdonis 10y ago
> A shorter distance that is closer to the combustion chamber increases the compression ratio because there is less space for the fuel/air mixture. When the system is operating in low compression mode the piston travels more and does not reach as high.
I think this is partly inaccurate. The images show the piston at the top of the stroke; when the compression ratio is high the piston is higher at the top of the stroke. But the bottom of the stroke is the same in both cases. That means the actual length of the stroke--the distance the piston travels--is greater in high compression mode. This is consistent with the definition of compression ratio, which is the ratio of cylinder volume at bottom of stroke vs. top of stroke; a larger compression ratio means a larger difference between these volumes, i.e., a longer piston stroke to get the piston higher (closer to the top of the cylinder) at the top of the stroke.
- asimuvPR 10y agoYes, you are correct. It was a mistake on my end. Thanks for pointing it out. I cannot update the post to fix the mistake. Hope people upvote your post to make sure it stays visible.
- TheSpiceIsLife 10y agoI don't follow how the stroke length changes. The conrod (upper-link in the image) is a fixed length, therefore the stroke length is fixed. The compression ratio changes because the mechanism changes where TDC (Top Dead Centre) is. Or have I misunderstood something? Edited to add: If TDC moves then the bottom of the stroke moves with it because the conrod is a fixed length, right?
- TheSpiceIsLife 10y agoNever mind, I see now how the mechanism changes the stroke length.
- zglennie 10y agoCan you elaborate? I'm trying to figure it out. I'm also confused about where the crankshaft is supposed to be in this picture.
- dogma1138 10y agoThe crankshaft is in the middle part it doesn't move in relation to the head. The image explains is pretty well, the piston is connected to the "multi-link" which changes the angle make the piston head move further into the cylinder.
- TheSpiceIsLife 10y agoErm, I'm not sure I get it. I think I'd need to see an animation. If the crankshaft is fixed I don't see how that linkage can change the stroke length because all it shows in that diagram is the piston further along the stroke, which is what all piston engines do when the crankshaft rotates. So yeah, I probably need to see an animation to grok it.