3 ms·
Good points for the most part, but: 1) 1mm and 0.8 mm BGAs are very common, and most of them can be handled with 5/5 trace/space rules supported by pretty much
by CamperBob2 10y ago
Good points for the most part, but:
1) 1mm and 0.8 mm BGAs are very common, and most of them can be handled with 5/5 trace/space rules supported by pretty much every board house. Many experienced people are actually more nervous when dealing with QFNs than with BGAs, primarily because of large thermal pads. 0.5 mm BGAs are where life starts to suck.
2) You can get a pretty good view of BGA solder quality with a "brush light," basically a bundle of optical fibers that go between the chip and the board. E.g., http://www.gen3systems.com/downloads/products/optiliabgainspectionsystem.pdf http://www.gen3systems.com/downloads/products/optiliabgainsp... (300 KB .pdf). If you have problems they will usually be pretty obvious -- it won't be that common for a single ball connection to be bad.
Re: reflow ovens, you may not really need one for prototyping. Hot air tools alone are fine for many applications (see below). A reflow oven would be nice to have but there are lots of more important tools to acquire first.
Re: avoiding hand rework, this is actually terrible advice. Get a good stereo microscope (AmScope is a decent economical brand), a good iron (meaning Metcal-class), and whatever cheap Chinese hot air tools are being hawked on eBay this week. If you're in this business, you are in the rework business, whether you like it or not. Might as well get used to it. (Pro tip: after the items above, your next purchase should be a preheater.)