3 ms·
FTA: > There were no notes on what resistors to fit - so I had to refer back to the schematic on the modules section of the RC2014 site. From here I was able t
by endgame 10y ago
FTA:
> There were no notes on what resistors to fit - so I had to refer back to the schematic on the modules section of the RC2014 site. From here I was able to confirm that they were 2K2 and also note the orientation. it's easy to get the one on the left of the FTDI header in the wrong orientation.
Did resistors become polarised when I wasn't looking?
- DanBC 10y ago> Did resistors become polarised when I wasn't looking? Some of the resistors are mounted vertically. Getting these the right way round is only important so other components physically fit on the board. I think the FTDI header has resistors that would interfere with an IC socket. EDIT: And it's nice to use a consistent orientation so it's easier to read the values so it's easier to check your work.
- dmytroi 10y agoProbably just so they look better in the final build.