3 ms·
If you plan to make one, make the radius smaller, but the velocity higher. The energy stored in this goes by the radius squared. But the centripetal force on t
by ars 17y ago
If you plan to make one, make the radius smaller, but the velocity higher.
The energy stored in this goes by the radius squared. But the centripetal force on the object at the end goes by the radius.
So a smaller faster one is less dangerous, and also requires a less powerful motor (or the motor you have can give you a higher force).
Although the bearings are probably a bit harder to handle when it's faster, the whole thing will weigh less.
On the con side, a smaller one will have a larger difference in force between the top and bottom of the lava lamp, making your experiment less accurate.
- westbywest 17y agoFaster RPM also increases velocity of would-be shrapnel. Either you prepare for the risk of a slowly-rotating, large rotor/axis assembly failing catastrophically, or a faster-rotating, smaller assembly shedding poorly-fastened bits from the ends of its rotor.
- ars 17y agoActually no. The velocity of the shrapnel tracks the energy stored in the device. Meaning a larger radius has faster shrapnel. Note: velocity as used in my earlier message is circular velocity, (AKA RPM), not linear velocity.
- rbanffy 17y agoThe velocity of the shrapnel is the same as the linear velocity of the part it detached from. If it detaches from a faster moving surface, it will fly faster.
- westbywest 17y agoSorry for fudging may response with a term for angular velocity, instead of linear velocity. I was writing from the assumption that the primary point of a smaller centrifuge would be to safely get higher centrifugal forces at the ends of the rotor, which would require that the ends of the shorter rotor move at greater linear velocity.
- Groxx 17y agoEnergy may go by radius squared, but the rpms change to match. For visualization: the ice-skater who spins slowly & pulls arms in. By spinning faster, no energy is lost, as can be seen by extending the arms. However, a slower-rotating device can more easily be predicted and avoided / hand-stopped if needed.
- rbanffy 17y agoThe energy is the same. A slower moving larger centrifuge can tear your arm off with the same ease a smaller, faster one.
- Groxx 17y agoTotally agree. But a smaller, faster one is less predictable, so you can't bleed of small amounts of energy as easily / safely. Which would you rather try to stop, with your bare hands, assuming identical energy? A 1-inch pipe spinning at 10,000 RPM, or a large tire spinning at 10?
- ars 17y agoIf the energy is identical, why would there be any difference? Remember that with the larger slower RPM one, the radius is higher so the linear velocity is high too, even if the RPMs are slow.
- Groxx 17y agoOne is more predictable than the other. In that video, I can point out when the arm will come around again with relative ease, and can very easily be accurate to below a tenth of a second. Now picture it going several times faster in terms of RPM, and tell me when it'd be safe to stick your arm in its path. Lets scale it up. Picture the earth. Near the equator, the linear velocity is almost 1000mph. Scale it down to the size of the centrifuge in the video, while keeping linear velocity the same. I can easily point out when half of the earth is facing the sun. Could you point out when the centrifuge is pointing north?