6 ms·
What about just installing a parallel port on your computer? http://www.amazon.com/StarTech-com-Express-Profile-Parallel-Adapter/dp/B001Q7X0Z8 http://www.amazon
by cortesoft 11y ago
What about just installing a parallel port on your computer? http://www.amazon.com/StarTech-com-Express-Profile-Parallel-Adapter/dp/B001Q7X0Z8 http://www.amazon.com/StarTech-com-Express-Profile-Parallel-...
- raimue 11y agoAnd miss all the fun hacking a custom solution? ;-) At least USB also works on a laptop, which is easier to put next to the console in the living room.
- downvotemyjokes 11y agoThat will likely suffer from the same drawbacks as 'installing' a parallel port via USB. You still lack the timing precision required to bitbang out many of these protocols.
- jbott 11y agoShouldn't the PCIe bus fix that problem? I would assume the reason why usb converters do not work would be due to the fact that usb uses a host controlled polling system, resulting in discrete timing that can only be as precise as the bus speed.
- laurencerowe 11y agoI think the timing problems are caused by the USB protocol. A PCI parallel port shouldn't suffer from those problems. (I think they were originally connected over the ISA bus, with the ISA controller connected to the PCI bus once that was introduced.)
- i736680 11y agoUSB latency is generally 0.25ms. PCI-Express latency is around 250ns. That's three orders of magnitude lower. I'm not sure how you can say that this will suffer from the same problem.
- downvotemyjokes 11y agoI'd wager the device hanging off the PCIe bus looks very little like a traditional parallel port to the CPU. Notice the modes supported by the device don't mention 'RAW', and a number of reviews bitch about ECP not working. Just because it is on pcie doesn't mean it isn't just emulating the most frequently used parts of a parallel port.
- n00b101 11y agoI have successfully used a StarTech PCIe parallel port adapter card to interface with a stepper motor controller board, and I'm able to run CNC machining operations from LinuxCNC. It works fine in EPP mode (communicating bi-directionally). The parallel port is actually very cool. You can take a high-end Linux machine and add the parallel port as a low latency GPIO interface with 25 pins. It can be used to control LEDs, motors, etc, and can also be used to receive sensor data, etc. What is 'RAW' mode? I think you are referring to a legacy TCP/IP network printing protocol also known as "Port 9100." I'm not sure that's relevant to parallel ports?
- downvotemyjokes 11y agoBy 'RAW', I mean being able to drive the port by poking at 0x378 in a highly controlled manner. (Not terribly uncommon when the hardware in the article was originally released)
- qb45 11y ago0x378 is probably routed to the onboard LPT by the BIOS. However, I wouldn't be surprised if those PCI cards used the same IO port protocol, only at some different address assigned in the standard way with PCI BARs.
- stevetrewick 11y agoThis has been my experience when trying to interface with some legacy LPT stuff, much of the software of the era is basically hard coded to do that and won't play well with (or sometimes even recognise) the PCIe add on ports. YMMV, clearly.
- digi_owl 11y agoI swear, Startech sells just about anything ports related.