3 ms·
A few bits of advice to those considering this... I had a 12-drive setup a few years ago, it eventually crashed and burned, because of several errors on my part
by tracker1 11y ago
A few bits of advice to those considering this... I had a 12-drive setup a few years ago, it eventually crashed and burned, because of several errors on my part. (surrounding ZFS)
Use a MB with ECC Ram (Asus + AMD seems to be the most cost effective option here). Also, you should max out the ram on the board, especially if you're aiming for a raid z2 array of more than 10GB (I did max my ram, but didn't go ECC).
Source the same drive from as many places as possible to try to get different mfg runs. I had really bad luck here, about 3/4 of the seagate drives I'd purchased died in under 2 years... The drive model itself had a really poor quality and many people had issues with these drives dying a short death.
Ensure your "hot spare" drives work... I'd configured for 2 hot spare drives, however, there was a bug in the version of FreeNAS I was using that caused the hot spares to not go into usage automatically.
Make sure that anything important on your NAS is backed up... if it's only on the NAS, that is not a backup. Hardware can and will fail. I tend to not consider something backed up unless it is in at least 3 copies and at least 2 different locations.
Overall, it was just a piss-poor experience, in the end I went back to Synology for my NAS usage... I spent a lot of money in hopes of having a close to "final" NAS solution, with a lot of defective hardware, a lot of failures, and in general, my "backup" NAS was more reliable. There's something to be said for buying a solution vs. DIY.
I might consider it again in a few years, but am more likely to just get a 5-8 drive product over DIY again. Drives have gotten a lot larger... at the time I went with 3TB, and 4TB were just starting to come out.