Execute CMD0 to make the card idle Execute CMD8 to enable ask about the voltage requirements Execute ACMD41 with S18 bit enabled and log for S18 in the reply

Execute CMD0 to make the card idle Execute CMD8 to enable ask about the voltage requirements Execute ACMD41 with S18 bit enabled and log for S18 in the reply to see if the card has voltage switch functionality: checked and the card has the functionality Now execute CMD11, if the card replies with a response the voltage switching sequence is started, the cmd and data line should go low: checked and yes they do Stop the clock, Program the voltage switch reg (with 1.8V) and wait 5 ms Start the clock: the card should start at speed SDR12 with 1.8V: cmd and data lines should go high, a cmd_done interrupt should be received: NOT RECEIVED Any pointers regarding this would be helpful...the card status registers shows that there is a data transfer in progress and the card is not present. After this I cannot execute any CMD (the cmd_done interrupts are not received)