4 ms·
What also has changed: no I2S connector for audio chips any more, and I had hoped for a proper 3-lane I2S to be able to do 5.1 HQ audio without relying on eithe
by mschuster91 11y ago
What also has changed: no I2S connector for audio chips any more, and I had hoped for a proper 3-lane I2S to be able to do 5.1 HQ audio without relying on either the crappy USB bus itself or cheap quality USB interfaces.
Not to mention that I2S sound is far less workload on the CPU than USB sound.
Oh, and why doesn't the Wifi/BT antenna have an SMA connector for external antennas, e.g. directional antennas?!
- antocv 11y agoDoesnt HDMI audio provide as good quality as any i2s connector? Or do you just need i2s for interfacing with your own microcontrollers/older recieviers, which dont necessarily have hdmi (and thus copyright compliance, making it more expensive)? Last I read Raspberry Pi should allow for 5.1 hdmi passthrough or at least DTS.
- mschuster91 11y agoHDMI audio requires an extractor (so one more wall wart + device), and I'm using a Pi2 for home cinema. And I'm one of those with an "old" HiFi setup without digital input, just analog.
- nl 11y agoSo use an old RPi? Or a Model B?
- newman314 11y agoIt does and that's how I have it set up. RPi source to receiver over HDMI. DTS 1080p movies playback beautifully with a slight overclock (on an original B).
- theli 11y agoRPI's hardware doesn't support DTS-HD MA or Dolby TrueHD passthrough though :(
- kingosticks 11y agoHang on, really? So there is no scope for any sort of compact HifiBerry-like dac with a Pi3?
- gchadwick 11y agoWas there a seperate I2S connector or do you mean they're not routing those connections to the GPIO any more? I believe this board: https://www.hifiberry.com/ https://www.hifiberry.com/ and the various other similar boards just connect via GPIO and use I2S
- whiskers 11y agoThe I2S interface is still present on the 40-pin GPIO as per the Pi2 and B+.
- kingosticks 11y agoCheers for clarifying that. Might have been the end for hifiberry, iqaudio etc otherwise
- mschuster91 11y agoThanks for the information, I was under the impression that the Pi 2 also used P5... but indeed it's on the 40 pin header now (http://www.pagemac.com/projects/i2s_amp http://www.pagemac.com/projects/i2s_amp) Now if one could repurpose another 2 GPIO pins for bit-banging I2s... there are chips which support multichannel, see http://www.ti.com/lit/an/snla221/snla221.pdf http://www.ti.com/lit/an/snla221/snla221.pdf page 5.
- makomk 11y agoIf you have the technical skills to make it work it might be worth looking into the AC97 interface on some of the Allwinner boards. I'm not sure anyone's tried using it yet and some driver development will be required though.
- fanf2 11y agoThere are pads underneath the antenna on the reverse side of the board, so it is possible to add an external antenna with some hacking.