4 ms·
It was interesting to learn that charges were per word and not per character. And that "2nd" counts as two words while "second" is one, dispite being twice the
by ams6110 11y ago
It was interesting to learn that charges were per word and not per character. And that "2nd" counts as two words while "second" is one, dispite being twice the number of characters.
Weren't all telegrams sent by morse code on the wire? Or was there another protocol?
- mistagiggles 11y ago"When groups of figures are spelled out, the chance of an error in transmission is reduced to a minimum." I guess its easier for the receiving operator to detect the error in "One Thosand" compared to "100" when coming over in serial (Original message being "One Thousand" and "1000" respectively).
- yrro 11y agoThere were entire dictionaries compiled so that words in a telegram could be kept to a minimum. https://archive.org/stream/adamscablecodex00cogoog#page/n22/mode/2up https://archive.org/stream/adamscablecodex00cogoog#page/n22/... A couple of extracts from the preface: The value of this code will be seen at a glance. We will suppose that the friend abroad is in Paris and is about to leave for London and wishes to apprise his friend at home of that fact. He turns to the Index and finds sentences beginning with "Am going to," "Am leaving for," etc., are to be found on pages 80 to 82, and then makes up the following message:— "INGRATE, LONDON, TUESDAY," which, when trans- lated by the receiver, means, "Am going to London and expect to reach there Tuesday morning. Telegrams sent to me there shall reach me promptly." In this message twenty words are sent at the cost of but three. And, Furthermore, in sending and receiving messages, do not fail to take time to read the telegram carefully, and re-check it to and from the code. Too much care cannot he taken in the translation of cable messages, as an error may cost both the sender and the receiver a deal of trouble, worry, and expense.