3 ms·
Again, powerline ethernet isn't ideal. It's two selling points are (1) not having to run a new cable, and (2) significantly improved latency and packet loss co
by paulmd 11y ago
Again, powerline ethernet isn't ideal. It's two selling points are (1) not having to run a new cable, and (2) significantly improved latency and packet loss compared to wifi while maintaining reasonable bandwidth. I normally get about 70-80 mbps across my PLE adapters. It is susceptible to picking up some interference at times, which cuts performance in half, but during those times the wifi is unusable for any sort of realtime/latency-sensitive applications. I have local GigE segments in my living room and computer room, but I would need to run a drop to connect them and I rent.
USB-C and Thunderbolt are point-to-point bus connectors, they're not designed to have multiple clients on a network. Even if you designed a switch that could use ethernet-over-Type-C as a physical layer, the maximum length for an active cable is only 50 feet for USB 3.0 speeds and 82 feet for 2.0 speeds. Passive cables are 15ft. That's not really enough for long runs inside a wall, so we're back to asking the question: OK, I plugged my USB Type-C into the wall. Now what?
If you're going to actually run a new cable to your outlets, running Type-C seems like a poor choice. You could stick a Type C ethernet adapter in a wall-socket formfactor, run CAT-6 in the walls, and call it a day. That gets you runs of up to 330ft for GigE. But if your vision is "plug into the wall and instantly get on my network, without pulling ethernet to every outlet" then you need something that runs over a power-line, because that's the only wire that's guaranteed to be run to a power outlet.
- cm2187 11y agoAgain, not powerline ethernet. You can create a custom connector for your power plug (power plug to device) with 40-ish pins that make all the individual wires go through one cable (2 pins for power, 8 for ethernet, 10 for USB, 19 for HDMI, and I am sure there are synergies). Then the power supply has an ethernet socket, USB socket, etc, and all your accessories (printer, TV, etc) are connected to the power supply instead of connected to the device. The surface dock does effectively that, except that I suspect they only pass a USB3 wire along the power, and have a USB switch inside the dock, and that ethernet goes over USB instead of directly.