3 ms·
If you think that's expensive, have a look at an OXTS RT3000 [1] where you can spend closer to $20,000 - that's the sort of thing you buy for your prototype sel
by michaelt 11y ago
If you think that's expensive, have a look at an OXTS RT3000 [1] where you can spend closer to $20,000 - that's the sort of thing you buy for your prototype self-driving car. Or at least, it was when people were competing in the DARPA Grand Challenge eleven years ago.
Applications for IMUs include dead reckoning (working out your position based on rotation and acceleration measurements), orientation sensing (figuring out which way is down is much easier than dead reckoning, because you can just sense gravity), and compensating sensor readings for robot motion.
Some cheap sensors aren't very precise; you won't notice if your phone thinks it's rotating two degrees a minute around the vertical axis, but a robot will if it moves for five minutes then it's ten degrees off course. I haven't looked at the market for a long time - I suspect the cheaper IMUs are better nowerdays. Eight years ago they didn't offer very good precision and the open source software could be very fiddly to get working, if you could get it working at all.
[1] http://www.oxts.com/products/rt3000-family/ http://www.oxts.com/products/rt3000-family/
- Animats 11y agoAt the 2004 DARPA Grand Challenge, the IMU/GPS unit that CMU's team used required 4U of rack space and air conditioning. There's been a lot of progress since then. The ADXRS642 MEMS gyro[1], which costs $50 in quantity, has a drift rate of 20°/hour. Ten years ago, you were lucky to get 20°/minute from a MEMS gyro. If you're doing sensor integration while moving, you need a stable orientation reference. Alternatively, you can use SLAM to process video and align to the world, which works well today. The OXTS RT3000 has impressive specs - 1cm accuracy in world coordinates. That's better than you need for most robotics applications that aren't running blind. The Trimble AP10 [2] has the same functionality at much lower cost, but is not as accurate. A lot of progress in robotics comes from component improvement like this. There was a time when just getting a wireless data link to your robot was a big deal. [1] http://www.analog.com/en/products/mems/mems-gyroscopes/adxrs642.html#product-overview http://www.analog.com/en/products/mems/mems-gyroscopes/adxrs... [2] http://www.trimble.com/gnss-inertial/AP10.aspx?dtID http://www.trimble.com/gnss-inertial/AP10.aspx?dtID