3 ms·
Wait, how can you break the BBB with a LED? I'm going to use one for a LEGO robot, and I'd like to not fry it :P
by StavrosK 11y ago
Wait, how can you break the BBB with a LED? I'm going to use one for a LEGO robot, and I'd like to not fry it :P
- hatsunearu 11y agoOur team has personally blown through three of them through shorting faults. It's our fault, but the BBB is a pretty tender beast.
- StavrosK 11y agoThat's too bad, it's pretty pricy :/ It's no $2 ESP8266, I wouldn't feel very bad shorting that, but at $70, I'm going to be super careful with my BBB.
- lemevi 11y agoThe gpio pins have low tolerance. Apply more than the 8mA or 3.3v and you permanently damage your board. LED's usually require 20mA to achieve a good brightness so you have to create a safe circuit using a bipolar transistor and the 3.3v power pin which supplies way more current than a gpio pin. If you hook up that transistor wrong or short the circuit it's game over. I actually think you can even damage the board if you create a short between the gpio pins and ground. So any kind of circuit requires a resistor, carefully reading the system manual and data sheets for your components and using ohm's law prior to hooking up components.
- StavrosK 11y agoThat's good to know, thank you. I'll have to only drive the MOSFETs with it, in that case, and avoid too much experimentation.