2 ms·
Here is what the software did, according to the EPAs letter to VW: Specifically, VW manufactured and installed software in the electronic control modul
by tzs 11y ago
Here is what the software did, according to the EPAs letter to VW:
Specifically, VW manufactured and installed software
in the electronic control module (ECM) of these
vehicles that sensed when the vehicle was being
tested for compliance with EPA emission standards.
For ease of reference, the EPA is called this the
"switch". The "switch" senses whether the vehicle is
being tested or not based on various inputs
including the position of the steering wheel,
vehicle speed, the duration of the engine's
operation, and barometric pressure. These inputs
precisely track the parameters of the federal test
procedure used for emission testing for EPA
certification purposes. During EPA emission testing,
the vehicles' ECM ran software which produced
compliant emission results under an ECM calibration
that VW referred to as the "dyno calibration"
(referring to the equipment used in emissions
tested, called a dynamometer). At all other times
during normal vehicle operation, the "switch" was
activated and the vehicle ECM software ran a
separate "road calibration" which reduced the
effectiveness of the emission control system
(specifically the selective catalytic reduction or
the lean NOx trap). As a result, emissions of NOx
increased by a factor of 10 to 40 times above the
EPA complian levels, depending on the type of drive
cycles (e.g., city, highway).
http://www3.epa.gov/otaq/cert/documents/vw-nov-caa-09-18-15.pdf http://www3.epa.gov/otaq/cert/documents/vw-nov-caa-09-18-15....