6 ms·
In my mind, I'm seeing a simpler solution that may be viable, enter the The "Claw Game" charger: * Attaches to ceiling of structure * Has some sort of sensor
by justlurkin 11y ago
In my mind, I'm seeing a simpler solution that may be viable, enter the The "Claw Game" charger:
* Attaches to ceiling of structure
* Has some sort of sensor to identify charging port, perhaps on the charger end itself
* Has some limited range of mobility - 2'x2' with X & Y axis movement
* Cord unreels down to the charging port once it is reasonably lined up
* Charging cable has Macbook style electromagnet, reaches "charging zone" and activates, inserting itself
* Safety checks are done, wattage is pumped into the cottage if all is well
I honestly don't know if this is better or worse, it's definitely less cool.
- Animats 11y agoThat could probably be made to work today, with the gear used by container cranes to slot containers onto ships, trucks, and railroad cars. It would be more complicated than the snake, because stabilizing a hanging load is hard. Once in a while it would probably scratch the car body. What a lot of people here aren't getting is that snake robots are mechanically simple. They're unusual, but neither complex nor expensive to manufacture.
- derefr 11y agoWould the claw still work if it was coated in soft rubber? Alternately, I'm imagining the cute-but-ridiculous solution of making the claw and the car magnetically repel one another, so as it the claw plumb-bobs downward and swings toward the car, it just sort of naturally veers away from the surface, rocking around it in an arc until it stabilizes.
- rcthompson 11y agoMake it so that the magnet is recessed inside a rim of soft plastic or rubber. Then it will still be able to slot onto the charge port but will not be able to hit the car body.
- hexasquid 11y agoT-600s were covered in rubber - turned out people could spot them easily, so they were poor infiltrators. Tesla should consider covering these with living tissue to make them more palatable to humans.
- Patrick_Devine 11y agoSome variation of this could potentially work with the Model S, or Model X, however the Model III will most likely have steel body panels instead of aluminum. I would imagine it would be next to impossible to line up the magnet correctly.
- Crito 11y ago> Attaches to ceiling of structure That's where my garage door goes.
- justlurkin 11y agoYou're telling me you don't have a 1+ feet of clearance above your garage door?